How To Light A Gas Water Heater Pilot Light

How To Light A Gas Water Heater Pilot Light. Use a flashlight while completing this process to make sure you can see everything clearly. Wait 5 to 10 minutes for any residual gas to clear out.

Hot Water Tank Pilot Light Quadrant Homes Howto Tip YouTube from www.youtube.com

It’s usually right on the panel. To light a gas water heater pilot light, you have to first search for the gas burner. Turn the water heat dial to low and the on/off/pilot dial to pilot.

Find The Gas Regulator Valve And Turn It To The “Off” Position.

Turn the gas valve to ‘pilot’ turn the gas valve to “pilot” and press down. Turn off the gas and open the pilot light access door/cover first, turn off the gas to your hot water heater for about 5 minutes. If there is air in the gas line, you might have.

Once Pressed, The Electrode Should Release The Spark.

If the pilot light goes out on a storage or instantaneous hot water heater, space heater or a ducted heater, you will not have a gas leak. Once the pilot light is on, continue holding the pilot set button or gas control knob for a minute so that the flame can heat the thermocouple, and generate enough electricity to keep the gas. Turn the gas knob to “pilot,” press and hold it down.

Final Tightening Of The Pilot And Gas Tubes To.

It’s usually right on the panel. Then, turn the on/off/pilot dial downwards and push the igniter button at the same time. When the pilot light goes out, you should know how to.

Once In The Pilot Position, Press The Control Knob Down Fully And Keep Holding It Down For 30 Seconds.

Steps to lighting a water heater with an electronic pilot step 1. Turn the gas knob to “pilot,” press and hold it down. To light a gas water heater pilot light, you have to first search for the gas burner.

Your First Step Is Obvious:

Turn the knob to pilot: Turn the gas control knob from on to pilot. Adjust the water heater’s temperature setting to the lowest possible level.

Leave a Reply

Your email address will not be published.