How To Test Suburban Water Heater Thermostat

How To Test Suburban Water Heater Thermostat. Read the terminal no.1 and 3 carefully, if you see the figure of 240v, it means the current is coming. Reseat the thermostat in the thermostat bracket so it.

Suburban 232319 Water Heater 140 Degree Thermostat ECO Switch 12v eBay from www.ebay.com

If it is, you will have a reading of 240v on terminals 1 and 3. 1.1 march 8, 2013 the secondary switch is accessed by removing the cover from the back side of the water heater. And when it comes to thermostats, the device uses two of them generally.

1) Turn Off The Power To Your Water Heater.

1.1 march 8, 2013 the secondary switch is accessed by removing the cover from the back side of the water heater. Read the terminal no.1 and 3 carefully, if you see the figure of 240v, it means the current is coming. Fits all suburban sw series water heaters.

The Structure Of An Electric Water Heater Is Pretty Simple.

Water heater thermostat, fits suburban lp gas water. One should be sitting on the top of unit 1. Check your heater’s power connecting point.

Suburban Water Heater Sw6D Thermostat.

Step 1 turn the water heater circuit breaker off inside the main service panel. Push the red ‘reset’ button to set it with the water heater. On many trailers, there is a diagram on the basement storage door showing normal and bypass settings.

And When It Comes To Thermostats, The Device Uses Two Of Them Generally.

Disable the lower thermostat by rotating its dial to the least setting. But if there is no reading, check its power source. If your meter is analog, then tune the indicator at zero while touching both pins ends.

Petersen Waterers Livestock Sheep Horse Hog Cattle.

Water heater troubleshooting.pdf page | 5. Old suburban water heater started leaking at the tank so i replaced with sw6d 6 gal direct spark. Start by checking the thermostat terminals for the supply of power.

Leave a Reply

Your email address will not be published.