How To Turn Ignition Switch Without Key. Make a hole using a power drill in the car’s ignition cylinder slot. You will see the ignition switch after you have cleared away all the pieces.
Use a screwdriver or socket wrench to unscrew the mounting bolts (or screws) for the ignition switch. You will see the ignition switch after you have cleared away all the pieces. Then pull the paperclip to.
That Gives Your Car’s System Power.
Test fit the drill bit. Get the steering wheel out from its place for you to access the ignition lock cylinder. First of all, disconnect the battery from the car and.
Then Remove The Lock Washer And Return Spring And Removing The Cylinder.
Cut the power lines from the cylinders, strip the ends and then connect them by twisting the metal ends together. Turn it as far round in a clockwise direction that you can. Insert lock cylinder into housing in flange casting, ensure tab at end of cylinder aligns with slot in ignition drive gear.
Loosen The Clamp, Then Gently Remove The Lower Dash Cover.
Turn key to off position, allowing cylinder retaining pin to extend into. The ignition switch lock cylinder designs come in a variety. The only way to get out the ignition lock is to use a 3/4 inch drill through the center of the key hole and then dig out the debris and then you can put a screw.
Loosen The Screws To Get Rid Of The Lower.
Try to use the flat. Clean out the dirt from the hole. Look over the top of the ignition module until you find a hole that’s slightly smaller in diameter.
Key Won't Turn Ignition Ignition Lock Cylinder Chevy Silverado 1999 From Www.youtube.com.
Make a hole using a power drill in the car’s ignition cylinder slot. Place the clip inside the hole. Pull on both the paperclip and the screwdriver to gently slide the switch out of its current.